kuroの覚え書き

96の個人的覚え書き

OpenWRTいってみよう



dd-wrtは機能てんこ盛りのかわりに負担が大きそうなのに対し、OpenWrtは極めてシンプル。後から必要なコンポーネントを追加していける柔軟性があるようだ。逆に言うと要らない機能はインストールしなければいいわけだ。その分CUIでしか設定ができない。(注:x-wrtというパッケージを使えば可能)まあ、知らない設定は見なかった事にするdd-WRT。設定の存在に気がつかないopenWRT。どっちがいいのやら。

http://wiki.openwrt.org/OpenWrtDocs/Hardware/Fon/Fonera/

ここを参考に。

ファームはKamikaze7.09で行ってみる。

http://downloads.openwrt.org/kamikaze/7.09/atheros-2.6/


RedBoot> ip_address -l 192.168.1.2/24 -h 192.168.1.1
IP: 192.168.1.2/255.255.255.0, Gateway: 0.0.0.0
Default server: 192.168.1.1
RedBoot> load -r -b %{FREEMEMLO} openwrt-atheros-2.6-vmlinux.lzma
Using default protocol (TFTP)
Raw file loaded 0x80040800-0x801007ff, assumed entry at 0x80040800
RedBoot> fis init
About to initialize [format] FLASH image system - continue (y/n)? y
*** Initialize FLASH Image System
... Erase from 0xa87e0000-0xa87f0000: .
... Program from 0x80ff0000-0x81000000 at 0xa87e0000: .
RedBoot> fis create -e 0x80041000 -r 0x80041000 vmlinux.bin.l7
... Erase from 0xa8030000-0xa80f0000: ............
... Program from 0x80040800-0x80100800 at 0xa8030000: ............
... Erase from 0xa87e0000-0xa87f0000: .
... Program from 0x80ff0000-0x81000000 at 0xa87e0000: .
RedBoot> fis free
0xA80F0000 .. 0xA87E0000

ここでこの長さを16進数の引き算で求める。この場合は6F0000


RedBoot> load -r -b %{FREEMEMLO} openwrt-atheros-2.6-root.squashfs
Using default protocol (TFTP)
Raw file loaded 0x80040800-0x801607ff, assumed entry at 0x80040800
RedBoot> fis create -l 0x006F0000 rootfs  #ここにさっきの長さが入る
... Erase from 0xa80f0000-0xa87e0000: .....................................................................
..........................................
... Program from 0x80040800-0x80160800 at 0xa80f0000: ..................
... Erase from 0xa87e0000-0xa87f0000: .
... Program from 0x80ff0000-0x81000000 at 0xa87e0000: .
RedBoot> reset

再起動するとOpenWRTが立ち上がるはず。DD-WRTとちがって通信速度は9600のままなのでコンソールの設定は9600/n/8/1でOK

  1. PHY ID is 0022:5521

Ethernet eth0: MAC address 00:18:84:*:*:*
IP: 0.0.0.0/255.255.255.255, Gateway: 0.0.0.0
Default server: 0.0.0.0

RedBoot(tm) bootstrap and debug environment [ROMRAM]
Non-certified release, version v1.3.0 - built 16:57:58, Aug 7 2006

Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc.

Board: ap51
RAM: 0x80000000-0x81000000, [0x80040450-0x80fe1000] available
FLASH: 0xa8000000 - 0xa87f0000, 128 blocks of 0x00010000 bytes each.
== Executing boot script in 1.000 seconds - enter ^C to abort
RedBoot> fis load -l vmlinux.bin.l7
Image loaded from 0x80041000-0x80290085
RedBoot> exec
Now booting linux kernel:
Base address 0x80030000 Entry 0x80041000
Cmdline :
Linux version 2.6.21.5 (nbd@ds10) (gcc version 4.1.2) #2 Sun Sep 30 20:16:16 CEST 2007
CPU revision is: 00019064
Determined physical RAM map:
memory: 01000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Built 1 zonelists. Total pages: 4064
Kernel command line: console=ttyS0,9600 rootfstype=squashfs,jffs2 init=/etc/preinit
Primary instruction cache 16kB, physically tagged, 4-way, linesize 16 bytes.
Primary data cache 16kB, 4-way, linesize 16 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 64 (order: 6, 256 bytes)
Using 92.000 MHz high precision timer.
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Memory: 13504k/16384k available (1955k kernel code, 2880k reserved, 292k data, 116k init, 0k highmem)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
Radio config found at offset 0xf8(0x1f8)
Time: MIPS clocksource has been installed.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 512 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP reno registered
squashfs: version 3.0 (2006/03/15) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver $Revision: 1.90 $ 1 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0xb1100003 (irq = 37) is a 16550A
eth0: Dropping NETIF_F_SG since no checksum feature.
eth0: Atheros AR231x: 00:18:84:22:a0:5c, irq 4
cmdlinepart partition parsing not available
Searching for RedBoot partition table in spiflash at offset 0x7d0000
Searching for RedBoot partition table in spiflash at offset 0x7e0000
5 RedBoot partitions found on MTD device spiflash
Creating 5 MTD partitions on "spiflash":
0x00000000-0x00030000 : "RedBoot"
0x00030000-0x000f0000 : "vmlinux.bin.l7"
0x000f0000-0x007e0000 : "rootfs"
0x001f0000-0x007e0000 : "rootfs_data"
0x007e0000-0x007ef000 : "FIS directory"
0x007ef000-0x007f0000 : "RedBoot config"
nf_conntrack version 0.5.0 (128 buckets, 1024 max)
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP vegas registered
NET: Registered protocol family 1
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 116k freed
eth0: Configuring MAC for full duplex
Warning: unable to open an initial console.
Algorithmics/MIPS FPU Emulator v1.5

  • preinit -

jffs2 not ready yet; using ramdisk
mini_fo: using base directory: /
mini_fo: using storage directory: /tmp/root

  • init -

init started: BusyBox v1.4.2 (2007-09-29 07:21:40 CEST) multi-call binary

Please press Enter to activate this console. device eth0 entered promiscuous mode
br-lan: port 1(eth0) entering learning state
br-lan: topology change detected, propagating
br-lan: port 1(eth0) entering forwarding state
PPP generic driver version 2.4.2
wlan: 0.8.4.2 (svn r2568)
ath_hal: module license 'Proprietary' taints kernel.
ath_hal: 0.9.30.13 (AR5212, AR5312, RF2316, TX_DESC_SWAP)
ath_rate_minstrel: Minstrel automatic rate control algorithm 1.2 (svn r2568)
ath_rate_minstrel: look around rate set to 10%
ath_rate_minstrel: EWMA rolloff level set to 75%
ath_rate_minstrel: max segment size in the mrr set to 6000 us
wlan: mac acl policy registered
ath_ahb: 0.9.4.5 (svn r2568)
ath_pci: switching rfkill capability off
ath_pci: switching per-packet transmit power control off
wifi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
wifi0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
wifi0: H/W encryption support: WEP AES AES_CCM TKIP
wifi0: mac 11.0 phy 4.8 radio 7.0
wifi0: Use hw queue 1 for WME_AC_BE traffic
wifi0: Use hw queue 0 for WME_AC_BK traffic
wifi0: Use hw queue 2 for WME_AC_VI traffic
wifi0: Use hw queue 3 for WME_AC_VO traffic
wifi0: Use hw queue 8 for CAB traffic
wifi0: Use hw queue 9 for beacons
wifi0: Atheros 2315 WiSoC: mem=0xb0000000, irq=3
jffs2_scan_eraseblock(): End of filesystem marker found at 0x0
jffs2_build_filesystem(): unlocking the mtd device... done.
jffs2_build_filesystem(): erasing all blocks after the end marker...


BusyBox v1.4.2 (2007-09-29 07:21:40 CEST) Built-in shell (ash)
Enter 'help' for a list of built-in commands.

_______ ________ __
| |.